| Step | | Procedure & Parts & Tools |
| 1 |
|
PUSH IN ON THE 2 ORANGE TABS TO REMOVE THE BASE COVER.
|
| 2 |
|
REMOVE THE BASE COVER.
|
| 3 |
|
LOOSEN THE BRUSH HEIGHT KNOB AND REMOVE IT. SET IT ASIDE.
|
| 4 |
|
FLIP THE BASE OVER AND REMOVE THE 5 SCREWS.
| Screwdriver-phillips |
|
|
| 5 |
|
FLIP THE BASE BACK OVER AND REMOVE THE BRUSH MOTOR COVER.
|
| 6 |
|
LOCATE THE 2 WHITE RING BRACKETS HOLDING THE UPPER BODY TO THE BASE. PULL OUT ON THE 2 WHITE RING BRACKETS. LAY THE UPPER BODY FLAT. PULL THE UPPER BODY AWAY FROM THE BASE TO SEPARATE IT FROM THE BASE.
|
| 7 |
|
REMOVE THE 6 SCREWS HOLDING THE VAC COVER TO THE UPPER BODY.
| Screwdriver-phillips |
|
|
| 8 |
|
PULL THE VAC COVER OFF TO EXPOSE THE VAC MOTOR.
|
| 9 |
|
LOCATE THE 2 BLUE WIRES IN THE TERMINAL BLOCK. SET THE VOLT METER TO VOLTAGE. INSERT THE VOLT METER LEADS INTO THE TERMINAL BLOCK (DOESNT MATTER WHICH LEAD GOES WHERE). PLUG THE MACHINE IN. ACTIVATE THE MACHINE.VOLT METER SHOULD READ APPROX. 120 VOLTS. IF THE VAC MOTOR IS OKAY,REVERSE STEPS 1 THRU 9 TO REASSEMBLE MACHINE.
| Volt meter (True RMS capable) |
&Width=100)
|
|